Differences

This shows you the differences between two versions of the page.

--- central_water_supply_system_touch2 [2025/11/25 13:52] – [Adjusting the water level] ishakeradmin
+++ central_water_supply_system_touch2 [2025/11/25 13:53] (current) – [Adjusting the water level] ishakeradmin
@@ Line 17: / Line 17: @@
   - Press the CONTROLLER REBOOT button or reset the machine from the screen on the Drinks tab.
   - Make sure that error 1 "No Water" doesn't appear on the screen after restarting the machine. If the error persists, check the water level in the mixer.
-  - Open the service menu, press the "Developer Mode" button, go to the {{ :t2-watercalibration.png?linkonly |Configurator tab - Calibration value}}, and calibrate the water supply using a measuring cup.
+  - Open the service menu, press the "Developer Mode" button, go to the {{ :t-conversionfactorscreen.png?linkonly |ConversionFactor}} tab, and calibrate the water supply using a measuring cup.
@@ Line 31: / Line 31: @@
   - Open the service menu and rinse the mixers by pressing buttons 1-4 on the screen one by one.
   - Press {{ :t-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}. service button . After the machine restarts, make sure that the No Water error 1 is no longer displayed on the screen.
-  - After setting the water level, check the water output in the service menu {{ :t-conversionfactorscreen.png?linkonly |ConvertionFactor}} tab.
+  - After setting the water level, check the water output in the service menu {{ :t-conversionfactorscreen.png?linkonly |ConversionFactor}} tab.
 The water supply connection setup is complete.
@@ Line 38: / Line 38: @@
 ====== Possible problems ======
-In some cases, if the water pressure in the water supply system is high, the solenoid valve may not open (the machine displays error 1, and no water flows when reset). The solution is to reduce the pressure by turning {{ :t2-pipeline-ajusting.png?linkonly |the regulator}}, counterclockwise a few turns, then press CONTROLLER REBOOT and ensure that water begins to flow into the line. **After any changes in water pressure, you must calibrate the water in the {{ :t-conversionfactorscreen.png?linkonly |ConvertionFactor}} tab**.
+In some cases, if the water pressure in the water supply system is high, the solenoid valve may not open (the machine displays error 1, and no water flows when reset). The solution is to reduce the pressure by turning {{ :t2-pipeline-ajusting.png?linkonly |the regulator}}, counterclockwise a few turns, then press CONTROLLER REBOOT and ensure that water begins to flow into the line. **After any changes in water pressure, you must calibrate the water in the {{ :t-conversionfactorscreen.png?linkonly |ConversionFactor}} tab**.