Differences

This shows you the differences between two versions of the page.

--- error_5_no_cup_usa [2025/11/05 15:47] – [Error 5: No cup] ishakeradmin
+++ error_5_no_cup_usa [2025/11/05 15:50] (current) – ishakeradmin
@@ Line 9: / Line 9: @@
 If an error occurs, press the {{ :t-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}. Check remain of cup in the receiving tube.
-After rebooting, press the {{ :t-service_mode.jpg?linkonly |SERVICE MODE}} and press the "Cup Test" button in Wash tab. The handle will move to a position under the dispensing unit, and the dispenser will release one cup and drop it into the catch fork.
+After rebooting, press the {{ :t-service_mode.jpg?linkonly |SERVICE MODE}} and press the {{ :t-cuptestbutton.png?linkonly |"Cup Test"}} button in Wash tab. The handle will move to a position under the dispensing unit, and the dispenser will release one cup and drop it into the catch fork.
 ----
@@ Line 48: / Line 48: @@
   - Perform the cup  test and check it fall to fork. Repeate the steps to free cup fall.
-In some cases, the problem with dispensing the cup remains even after calibration; the cup may get stuck during dispensing and not fall into the catcher:
+In some cases, the problem with dispensing the cup remains even after calibration; the cup may get stuck during dispensing and not fall into the catcher.
-{{ :ролики_выдача_т.jpg?nolink&300 |}}
+Push the cups out of the tube and inspect the guide rollers - they should all be facing the same direction.
-{{ :проблема_с_выдачей_1.jpg?nolink&300 |}}
- Push the cups out of the tube and inspect the guide rollers - they should all be facing the same direction:
-{{ :отщепитель_ролики.png?nolink&600 |}}