Differences

This shows you the differences between two versions of the page.

--- service_maintenance_t1 [2025/11/07 14:29] – [Assembly/disassembly of mixers] ishakeradmin
+++ service_maintenance_t1 [2025/11/07 14:37] (current) – [Setting up the cup sensor] ishakeradmin
@@ Line 133: / Line 133: @@
 {{ :t-cupdispencerfitting.jpg?nolink&400 |}}
-Push the stack of glasses up and press it down by sliding the flag to the right. Make sure the glass is locked in place and pull it down until the edge of the glass rests on the top of the guide rollers.
+Push the stack of cups up and press it down by sliding the flag to the right. Make sure the cups is locked in place and pull it down until the edge of the cups rests on the top of the guide rollers.
 {{ :t-cupdispencerfitting1.jpg?nolink&200 |}}
@@ Line 142: / Line 142: @@
 ===== Setting up the cup sensor =====
-Cup sensor calibration must be performed directly at the vending machine installation site by trained personnel. Sensor sensitivity depends on ambient temperature, so any adjustments to the sensor must be performed under stable temperature conditions (a critical requirement during colder seasons).
+Sensor sensitivity depends on ambient temperature, so any adjustments to the sensor must be performed under stable temperature conditions (a critical requirement during colder seasons).
 **ATTENTION! Due to the specific operation of the cup sensor, it is not recommended to use red or black cups.**