====== Error 1 No Water ======
===== Touch model =====

Reasons for appearance:
  * Lack of water
  * Air lock in the system
  * Incorrect water supply connection settings
  * Technical malfunction


To reset the error, press the {{ :t-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}switch . If the error persists, start the {{ :t-pumpingwaterbutton.png?linkonly |pumping water}} in the service menu.

If the error reappears after rebooting, run diagnostics:
  * Make sure that the taps and the pump/water supply switch are installed in the correct position, corresponding to the connection;
  * The pump is at the bottom of the tank, the water has not run out (with this type of connection);
  * The pump hose is not pinched or kinked;
  * The pressure in the water supply system (with this type of connection) is not lower than 0.15 - 0.8 MPa (1.5 - 8 bar).
  * The water level when rinsing the mixer/pumping water is not less than the optimal level (picture below):
{{ :воронка_миксера_уровень_воды.jpg?nolink&300 |}}

Each connection type uses a separate setting.


----

===== Adjusting the water supply when using a pump  =====
To adjust the settings, you'll need a small "-" screwdriver. The adjustment is made by turning the adjustment screw on the UPS board at the backside of machine.
{{ :t-ups-pmp.jpg?nolink&300 |}}
  - Using a screwdriver, turn the adjusting screw clockwise by 1 turn.
  - Run the mixer flush (or water pumping) in the service menu.
  - Visually check the water level in the mixer and readjust if necessary.
**If there is excess pressure, adjust the pressure back by turning the screw counterclockwise.**
----
===== Setting up the water supply when connecting to the water supply  =====
You will need a "+" screwdriver to adjust.
{{ :t-wtrline-regulator.jpg?nolink&400 |}}
  - Using a screwdriver, turn the regulator clockwise by 1 turn.
  - Run the mixer flush (or water pumping) in the service menu.
  - Visually check the water level in the mixer and readjust if necessary.
**If there is excess pressure, adjust the pressure back by turning the regulator counterclockwise.**

----
====== Question / Answer ======

**Question: ** I ran out of water, and the machine has been in an error state for a while. When I restart and pump, the water doesn't flow, or flows very slowly, and the settings don't work. What should I do?


**Answer:** Turn off the machine's cooler for 30 minutes, then {{:t-pumpingwaterbutton.png?linkonly pumping|pump}} the water. Without water, the cooler freezes and shuts off the water supply.

----

**Question:** The machine doesn't reset the error after multiple reboots. The pressure is normal, and water flows when rebooted. Sometimes the error resets, but reappears the first time I make a drink. What should I do?

**Answer:** The watermeter needs to be changed.

----

**Question:** When resetting, no water flows; the machine operates on a submersible pump. The valves and toggle switch are installed correctly. What should I do?

**Answer:** Reset the machine and inspect the pump. If the pump doesn't turn on after resetting, change it.