====== Connection to a water tank using a pump ======

**Rules and order of connection:**

  - Remove the pump and hose from the shipping packaging: {{ :wtrpmp.jpg?nolink&200 |}}
  - Connect the cable connector and hose to the connectors on the back of the machine: {{ :pmpcnc.jpg?nolink&200 |}}
  - Put the pump to the bottom of the water tank: {{ :pmpinbottle.jpg?nolink&200 |}}
  - Move the water supply switch to the down position: {{ :wtrsplybottle.jpg?nolink&200 |}}
  - Turn the taps as shown in the picture below: {{ :wtrsplybottle2.jpg?nolink&200 |}}
  - Start the machine, wait for the software to load. When you first start it, the message [[sms_error_1_usa|Error 1 No Water]] will appear on the screen.
  - Press {{ :ms-servicemode.jpg?linkonly |SERVICE MODE}} button, place the cup in the dispensing window, press {{ :sm-_pumping_water.png?linkonly |Pumping water}} on the machine screen.
  - The machine will start the process of filling the system. Water will start flowing through mixer #1 and the hose into the dispensing window. Wait until the process is complete. Repeat pumping until the water flow is stable and the air bubbles disappear.


----
 

===== Setting the water level =====



  - Start pumping and check the water level in the mixer funnel (see the picture below). The optimal level is indicated by a green stripe, red - excessive or insufficient level: {{ :воронка_миксера_уровень_воды.jpg?nolink&300 |}}. 
  - In case of insufficient or excessive water level, it is necessary to adjust the pump voltage. For adjustment, you will need a small "minus" screwdriver. Adjustment is carried out by turning the right adjustment screw on the back panel of the machine during water pumping. {{ :регулировка_напряжения_s.png?nolink&300 |}}
  - To increase the water flow, turn the right screw clockwise, to decrease - counterclockwise. Check the water level in the funnel. If the level does not correspond to the optimal indicators - repeat the process.
  - Open the service menu and wash the mixers by pressing {{ :sm-_12washmixer.png?linkonly |1 and 2}} on the screen one after the other.
  - Press the service button {{ :ms-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}. After the machine reboots, make sure that [[sms_error_1_usa|Error 1 No Water]]  is not displayed on the screen.
  - After setting the water level, check the water output in the service menu "Conversion factor".

The water supply connection setup is complete.