====== Connecting to a water tank using a pump (Touch) ======

**Rules and procedure for connection:**

  - Lower the pump to the bottom of the{{ :pmpinbottle.jpg?linkonly |water tank.}}.
  - Move the {{ :t-bottletumbler.jpg?linkonly |water supply switch}} to the down position.
  - Turn the taps as shown in {{ :t-bottlewtrcran.jpg?linkonly |the picture}}.
  - Unwind the fishing line with the {{ :t-wastesensor1.jpg?linkonly |waste sensor}} float. The float should hang freely into the waste container, and the sensor should be in {{ :t-wastesensor.jpg?linkonly |the lower position}}. 
  - Start the machine. After power is applied, the pump will turn on for 1-2 seconds. After the software loads, the message "Error 1 No Water" will appear on the screen.
  - Press the {{ :t-service_mode.jpg?linkonly |SERVICE MODE}} and press the {{ :t-pumpingwaterbutton.png?linkonly |“Water pumping”}} button on the machine’s screen.
  - The machine will begin filling the system. Once the system is filled, water will begin flowing through mixer #1 and the hose into the drain tank. Wait for the process to complete.


----


===== Adjusting the water level =====


  - Start pumping and check the water level in the mixer funnel (refer to the picture below): {{ :воронка_миксера_уровень_воды.jpg?nolink&300 |}}
  - If the water level is too low or too high, the pump voltage needs to be adjusted. A small "-" screwdriver is required for this adjustment. The adjustment is made by turning the adjustment screw on the UPS board (on the backside of machine): {{ :t-ups-pmp.jpg?nolink&400 |}}
  - To increase the water flow, turn the screw clockwise; to decrease it, turn it counterclockwise. Check the water level in the funnel.
  - Open the service menu and rinse the mixers by pressing buttons 1-4 on the screen one by one.
  - Press {{ :t-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}. After the machine restarts, make sure [[error_1_no_water_touch_usa|Error 1 No Water]] is no longer displayed on the screen.
  - After setting the water level, check the water output in the {{ :t-conversionfactorscreen.png?linkonly |"ConversionFactor"}} tab.

The water supply connection setup is complete.