Differences

This shows you the differences between two versions of the page.

--- central_water_supply_system_touch2 [2025/11/25 13:53] – [Possible problems] ishakeradmin
+++ central_water_supply_system_touch2 [2025/11/25 13:53] (current) – [Adjusting the water level] ishakeradmin
@@ Line 17: / Line 17: @@
   - Press the CONTROLLER REBOOT button or reset the machine from the screen on the Drinks tab.
   - Make sure that error 1 "No Water" doesn't appear on the screen after restarting the machine. If the error persists, check the water level in the mixer.
-  - Open the service menu, press the "Developer Mode" button, go to the {{ :t-conversionfactorscreen.png?linkonly |ConvertionFactor}} tab, and calibrate the water supply using a measuring cup.
+  - Open the service menu, press the "Developer Mode" button, go to the {{ :t-conversionfactorscreen.png?linkonly |ConversionFactor}} tab, and calibrate the water supply using a measuring cup.
@@ Line 31: / Line 31: @@
   - Open the service menu and rinse the mixers by pressing buttons 1-4 on the screen one by one.
   - Press {{ :t-controller_reboot.jpg?linkonly |CONTROLLER REBOOT}}. service button . After the machine restarts, make sure that the No Water error 1 is no longer displayed on the screen.
-  - After setting the water level, check the water output in the service menu {{ :t-conversionfactorscreen.png?linkonly |ConvertionFactor}} tab.
+  - After setting the water level, check the water output in the service menu {{ :t-conversionfactorscreen.png?linkonly |ConversionFactor}} tab.
 The water supply connection setup is complete.