Differences

This shows you the differences between two versions of the page.

--- water_tank_connection_touch [2025/11/05 15:24] – [Connecting to a water tank using a pump (Touch)] ishakeradmin
+++ water_tank_connection_touch [2025/11/05 15:24] (current) – ishakeradmin
@@ Line 5: / Line 5: @@
   - Lower the pump to the bottom of the{{ :pmpinbottle.jpg?linkonly |water tank.}}.
   - Move the {{ :t-bottletumbler.jpg?linkonly |water supply switch}} to the down position.
-  - Turn the taps as shown in the picture.
+  - Turn the taps as shown in {{ :t-bottlewtrcran.jpg?linkonly |the picture}}.
   - Unwind the fishing line with the {{ :t-wastesensor1.jpg?linkonly |waste sensor}} float. The float should hang freely into the waste container, and the sensor should be in {{ :t-wastesensor.jpg?linkonly |the lower position}}.
   - Start the machine. After power is applied, the pump will turn on for 1-2 seconds. After the software loads, the message "Error 1 No Water" will appear on the screen.