Differences

This shows you the differences between two versions of the page.

--- water_tank_connection_touch2 [2025/11/25 13:44] – created ishakeradmin
+++ water_tank_connection_touch2 [2025/11/25 13:48] (current) – [Pump setup] ishakeradmin
@@ Line 12: / Line 12: @@
   - Press the CONTROLLER REBOOT button or reset the machine from the screen on the Drinks tab.
   - Make sure that error 1 No water is not displayed on the screen after restarting the machine.
-  - Open the service menu, press the "Developer Mode" button, go to the {{ :t2-watercalibration.png?linkonly |Configurator tab - Calibration value}}, and calibrate the water supply using a measuring cup.
@@ Line 28: / Line 27: @@
 The default value is 40%. Moving the slider to the left will decrease the pressure, while moving it to the right will increase it. To save the change, be sure to click the "Save" button. **It is not recommended to increase or decrease the pressure drastically; change the value by 10% at a time, be sure to save the change, reboot the machine, and check for error 1**.
-**After changing the PWM setting, {{ :t2-watercalibration.png?linkonly |water calibration}} is required to correctly calculate drink dosages.**
+**After changing the PWM setting, {{ :t-conversionfactorscreen.png?linkonly |water calibration}} is required to correctly calculate drink dosages.**